+86-29-89284429
://Some Stories About The Sample Vial

Some Stories About The Sample Vial

Hawach sample vial is also called a sampling bottle, purification bottle, sterile bottle, clean bottle, filter bottle, filter bottle, sampling bottle, filter bottle and so on. It is in accordance with the international standard: ISO3722 “hydraulic drive· sampling vessel cleaning method identification” cleaning qualified special appliances. It is different from other liquid samplers, any beverage bottle shabu line. If the container is cleaned by itself, the contaminated base number (clean grade RCL value) in the container is not clear, the reliability of the final test result will be questioned.

The sample vials are divided into 150ml (PP plastic) outer diameter 50mm* diameter 22mm* bottle height 130mm; 250ml (glass) outside diameter 70mm* diameter 30mm* bottle height 140mm.It can replace the special sample bottle of HIAC PODS, the special sample bottle of imported HIAC and the special sample vial of imported graininess detector.

How to use the sample vial
1. If the cost is sufficient, it is better to use new ones every time.
2, if you want to reuse, the cleaning method is also very important, first with a strong oxidation cleaning solution (potassium dichromate) soak for 24 hours, then with deionized water under ultrasonic conditions three times, finally with methanol cleaning once, drying can be used.
3. The bottle pad must be replaced with a new one, especially when analyzing pesticide residues, otherwise, it will affect the quantitative results.
Recommended cleaning methods.
a. Rinse several times with tap water.
b. Put into a beaker with pure water and ultrasound for 15 minutes.
c. Change the water and ultrasound for 15 minutes.
4. Soak in a beaker with or without ethanol.5. Remove and air dry.

Snap Top Sample Vials
2ml Screw Thread Top Sample Vials

Types of the sample vial
sample vials are generally divided into three types: sample bottles with clamps, screw caps, and bayonet caps

How to choose the three sample vials?
The sealing of the clamp bottle itself is, of course, better than the threaded bottle, rubber or silica gel after puncture also has a good re-sealing, so it is ideal to preserve the reagent.

But if in the use of some organic solvent corrosion silicone or rubber bottle mat, so you need a bottle of PTFE coating, mat, if, in the use of reagent is not a finished, but in the sample bottle part such as the next reoccupy, then finished samples will evaporate, with a bottle of a PTFE coating pad after puncture seal will be lost.

It is recommended that some of the reagents without corrosion to the rubber or silica gel bottle pad can be stored in a clamp bottle, while for corrosive reagents, it is not recommended to use a clamp bottle seal. Compared with silicone, rubber has a better sealing property.

Bayonet sample bottles and bottle caps are simple and effective ways to ensure sealing without clamps. It’s as easy as pressing in and pulling out. The clamshell lid can also be used with a jar. The sample vial with a bayonet cap cannot be pressurized.

2020-01-10T00:56:54+00:00January 10th, 2020|